$7.99

Thumb Grip for Sony A7C, A7C II, A7CR

0 ratings
I want this!

Thumb Grip for Sony A7C, A7C II, A7CR

$7.99
0 ratings

Cold / Hot shoe Thumb Grip for the Sony A7CR, A7C II, & A7C. Improves ergonomics and security when holding the camera and helps to make up for the A7C lineup's small grip.

Notes:

  • This is an STL File. Units are in mm. This part has not been tested on other cameras.
  • I printed my copies out of 1.75mm PLA. Fit is very precise, so printing at high resolution, 100% density, and your smallest layer heigh is recommended. Print with bottom side down (requires supports).
  • As with most additive manufacturing, some post-processing of the print may be required - namely, cutting off/sanding of the bottom support structure. Due to the shape of this grip, there was no avoiding the use of supports. Sand in stages and fit test in-between until you achieve a smooth but snug installation.

I want this!

You'll receive the STL File, for use in 3D printing.

Size
172 KB
Copy product URL